ETI EX-88 Consumer Epoxy Kit - 7.6 L USC wooden bowls

wooden bowls

Non-paintable

and tie the strips of flash tape to the bottom of the balloon

For Best Results Before Pouring Clear Flex™ Into Mold: Pre-heat rubber mold at 212°F / 100°C for 4 hours

ETI EX-88 Consumer Epoxy Kit - 7.6 L USC wooden bowlsEX 88 is an extremely clear, tough, high gloss surface coating formulated to produce a deep glass like appearance in a single layer on a sealed surface. EX 88 has an open time of 25 minutes if poured immediately after mixing (70F). Warmer temperature will reduce open time, therefore it is recommended to pour immediately to allow for self leveling of the epoxy and maximum bubble release. EX 88 is waterproof, heat & alcohol resistant.